Customer Service Phone Hours: M: 9a - 4:30p / Tu-W-Th-F: 9a - 6p / Sat: 10a - 4p EDT

 

 

Check Valve and O-Ring Set for Super Jet Wine Filter for D48 Motor

Be the first to review this product

Check valve and o-ring set for Super Jet Wine Filter with D48 motor only. Check your motor model number! The motor model number is just above the serial number and should start with a D48!

Availability: In stock

$59.99
Item #5277
$59.99

Description

Details

Check valve and o-ring set for Super Jet Wine Filter with D48 motor only. Check your motor model number! The motor model number is just above the serial number and should start with a D48! Instructions to replace check valve for Superjet model D48XXXXX. 1. Unbolt the motor from the frame. 2. Turn the pump head towards you. You will notice 4 screws, take them out. 3. Remove the black pump head. 4. Remove the check valve. 5. On the check valve is the seal ring, remove it. 6. Remove the screen to make sure it is clean in behind. It would be a good idea to rinse everything out with water. Note: It is not necessary to put the screen back in, only if you wish. 7. Insert the new seal ring into the check valve. 8. Insert the new check valve into the pump head. At this point the inside should face flush. 9. Place the pump head back on the motor and replace the screws. Make sure you reassemble the hoses to the correct fitting. Then replace the whole unit on the frame as it was before you started. 10. It may on occasion happen that you will not get an immediate prime due to the check valve and seal ring being dry. Put your inlet tube up the tap and force water through to the pump, this should help prime it. (If your SuperJet is a model no 2000 series, please contact Buon Vino directly)

Reviews

Write Your Own Review

Only registered users can write reviews. Please, log in or register